Maintenance Schedule for Non European RD1's

CR-V 95-01 [RD1]

  1. Ichiban
    This Maintenance Schedule outlines the minimum required maintenance that you should perform to ensure the trouble-free operation of the customer's vehicle.
    Due to regional and climatic differences, some additional servicing may be required.
    Please consult the warranty handbook for a more detailed description.
    Service at the indicated distance or time whichever comes first km x 1,000 20 40 60 80 100 120 140 160 180 200
    miles x 1,000 12 24 36 48 60 72 84 96 108 120
    months 12 24 36 48 60 72 84 96 108 120
    Replace engine oil Every 5,000 km (3,000 miles) or 6 months
    Replace engine oil filter Every 5,000 km (3,000 miles) or 6 months
    Replace air cleaner element KZ model Clean every 10,000 km (6,000 miles) or 12 months and replace every 20,000 km (12,000 miles) or 24 months
    KU model
    Inspect valve clearance
    Check the valve clearance
    Replace fuel filter
    Replace spark plugs
    Inspect distributor cap, rotor and ignition wiring
    Check for cracks, wear, damage and fouling
    Replace timing belt and inspect water pump
    Check water pump for signs of seal leakage
    Inspect and adjust drive belts
    • Check for cracks and damage
    • Check deflection and tension
    • Alternator belt
    • Pump belt
    • A/C compressor belt
    Inspect idle speed and idle CO
    Replace engine coolant
    Check specific gravity for freezing point
    Inspect PCV valve
    Check the clicking sound of motion from the PCV valve of idling
    Inspect ignition timing
    Check for ignition timing
    Inspect evaporative emission control system
    • Check the EVAP control canister operation
    • Check the hose for blockage, cracks or disconnected
    Replace transmission fluid
    Genuine Honda ATF PREMIUM (Automatic Transmission Fluid-PREMIUM) or DEXRON II or III ATF
    Replace rear differential fluid
    Genuine Honda ATF PREMIUM (Automatic Transmission Fluid-PREMIUM)
    Inspect front brake
    • Check the brake pad thickness
    • Check the brake disc thickness
    • Check for damage or cracks
    • Check the wheel cylinder for leaks
    • Check the brake linings for cracking, glazing, wear, or contamination
    • Check the calipers for damage, leaks, and tightness
    Inspect rear drum brake
    Every 10,000 km (6,000 miles) or 6 months
    Replace brake fluid
    • Use only DOT 3 or DOT 4 (we recommend Genuine Honda Brake Fluid) fluid
    • Check that brake fluid level is between the upper and lower marks on the reservoir
    Check parking brake adjustment
    Check the parking brake operation
    Replace air conditioning filter Every 30,000 km (18,000 miles) or 12 months
    Rotate tyres
    • Check tyre inflation and condition at least once per month
    • The suggested rotation method is shown in the diagram
    Rotate tyres every 10,000 km (6,000 miles)
    Visually inspect the following items:
    • Check for correct installation and position, check for cracks, deterioration, rust, and leaks
    • Check tightness of screws, nuts, and joints. If necessary, retighten
    Tie rod ends, steering gearbox, and boots
    • Check rack grease and steering linkage
    • Check the boot for damage and leaking grease
    • Check the fluid line for damage and leaks
    Every 10,000 km (6,000 miles) or 6 months
    Suspension components
    • Replace suspension arms
      - Front
      - Rear
    • Replace knuckle/hub
      - Front
      - Rear
    • Check the bolts for tightness
    • Check the all dust cover for deterioration and damage
    Driveshaft boots
    • Check boots and boot band for cracks
    • Check rack grease
    Brake hoses and lines (including ABS)
    Check the master cylinder, proportioning control valve and ABS modulator for damage and leakage
    Cooling system hoses and connection
    • Check all hoses for damage, leaks or deterioration
    • Check all hose clamps. Retighten if necessary
    Exhaust system
    Check the catalytic converter heat shield, exhaust pipe and muffler for damage, leaks and tightness
    Tyre condition
    Check for pressure, puncture or cuts and irregular thread wear
    Inspect supplemental restraint system Inspect system 10 years after first registration