Suspension, Steering and Brakes ABS controller socket pin-nout

Discussion in '7th Generation (2003-2008) [Acura TSX]' started by jcalvarez, Sunday 1st Mar, 2015.

  1. jcalvarez Club Member ★ ☆ ☆ ☆ ☆

    Scotland Jose Dunfermline
    77
    17
    Hi Guys,

    I have an ABS warning light on all the time. I want to check whether the issue is the sensor, or the wiring, loose plug etc. Does anybody knows the pin-out of the connector that carries the wheel speed sensor signals to the controller?

    Many thanks,

    JC
     
    Loading...
  2. Nighthawk Guest

    United Kingdom Richard Milton Keynes
    5,369
    3,146
    14
    Best way is to just get the car scanned - costs around 50 quid from the dealer.

    In answer to your question though, I am sure someone will know the answer to it and will respond soon.
     
    Loading...
  3. SpeedyGee Administrator Staff Team

    England Speedy Birmingham
    14,999
    5,595
    4
    As @Nighthawk suggested the correct way would be to connect up Honda Diagnostic System to check for errors and read values from sensors.
     
    Loading...
  4. jcalvarez Club Member ★ ☆ ☆ ☆ ☆

    Scotland Jose Dunfermline
    77
    17
    I did, says the rear driver side sensor. I just want to know whether is the sensor itself or the cable.
    Thanks!
     
    Loading...
  5. SpeedyGee Administrator Staff Team

    England Speedy Birmingham
    14,999
    5,595
    4
    How about the disconnecting the sensor and seeing if the code changes ?
     
    Loading...
    Nighthawk likes this.
  6. jcalvarez Club Member ★ ☆ ☆ ☆ ☆

    Scotland Jose Dunfermline
    77
    17
    I need to remove the wheel for that, right?
     
    Loading...
  7. SpeedyGee Administrator Staff Team

    England Speedy Birmingham
    14,999
    5,595
    4
    Yes I would imagine so.
     
    Loading...
  8. jcalvarez Club Member ★ ☆ ☆ ☆ ☆

    Scotland Jose Dunfermline
    77
    17
    Thank you for your replies guys, will keep updated
     
    Loading...
  9. Nighthawk Guest

    United Kingdom Richard Milton Keynes
    5,369
    3,146
    14
    Just be careful trying to remove the ABS sensor from the hub - they get stuck in there pretty tight.
     
    Loading...
  10. jcalvarez Club Member ★ ☆ ☆ ☆ ☆

    Scotland Jose Dunfermline
    77
    17
    Thanks, I was just reading a thread on typeaccord.co.uk, basically almost everybody is having to drill the original sensor :Frown:
     
    Loading...