General Centre Console Removal

Discussion in '7th Generation (2003-2008) [Acura TSX]' started by Mark11, Saturday 30th Apr, 2016.

  1. Mark11 Club Member ★ ☆ ☆ ☆ ☆

    England Mark chesterfield
    105
    67
    Does anyone know how to remove the cup section of the centre console.
    i know how to get gear bit off and rear section where ashtray is.
    I need cup holder bit out.

    Any ideas, been yanking and it won't move. any hidden screws anywhere?
     
    Loading...
  2. Nighthawk Guest

    United Kingdom Richard Milton Keynes
    5,369
    3,141
    14
    2 screws underneath the gear lever shroud if memory serves me correctly, and the rest is clips. Pulls out.
     
    Loading...
  3. Mark11 Club Member ★ ☆ ☆ ☆ ☆

    England Mark chesterfield
    105
    67
    Cheers for that, I've been looking for ages.
    I've been trying to wire something up to the rear fag lighter, it worked but when i was reassembling it, it no longer works. think I've tugged a wire too hard somewhere. Checked fuses and its not that.
    Thanks again, ill try again tomorrow
     
    Loading...
  4. Nighthawk Guest

    United Kingdom Richard Milton Keynes
    5,369
    3,141
    14
    You need to remove the gearknob, unclip the gearlever shroud, then at the base of that shroud are two phillips screws, remove those and pull the centre cup holder upwards. Clips are on there pretty good - four of them I think it is
     
    Loading...
  5. Mark11 Club Member ★ ☆ ☆ ☆ ☆

    England Mark chesterfield
    105
    67
    thanks, ill look tomorrow
    thanks for replying
     
    Loading...
  6. Nels Moderator Staff Team

    Did you manage to do this ?
     
    Loading...
  7. Mark11 Club Member ★ ☆ ☆ ☆ ☆

    England Mark chesterfield
    105
    67
    yes i managed to do it as Nighthawk said, although there werent any screws in my cup holder i yanked it out and it came free. :Thumbup:
     
    Loading...
    Nels likes this.
  8. Nels Moderator Staff Team

    That's good. :Niceone:

    I only caught up with this tread last night, so was a little late to the party.
    If anyone else reading this wants to get these parts out, there are plenty of clips on the web and it is also covered as part of this guide.
    Handbrake Adjustment on my CN1
     
    Loading...