Electrical & Lights Condensation in foglight

Discussion in '3rd Generation (2006-2012)' started by Paul1000, Friday 11th Dec, 2015.

  1. Paul1000 Junior Member ☆ ☆ ☆ ☆ ☆

    United Kingdom Paul Neston
    14
    3
    hi, have a misted up foglight on my 59 CR-V cdti, how do you get at them?
     
    Loading...
  2. SpeedyGee Administrator Staff Team

    England Speedy Birmingham
    14,999
    5,591
    4
    From I gather, I think there should be a plastic under tray just under the bumper. Remove some clips for this on the side that you need to change the bulb, pull down the undertray so you can get your hand up behind the fog light, twist the bulb connector anti clockwise and pull it out.

    Change the bulb and reverse the above steps to refit.
     
    Loading...
  3. Paul1000 Junior Member ☆ ☆ ☆ ☆ ☆

    United Kingdom Paul Neston
    14
    3
    Cheers, I'm hoping it's the seal on the h11 bulb that is gone or it's a new foglight.
     
    Loading...
  4. SpeedyGee Administrator Staff Team

    England Speedy Birmingham
    14,999
    5,591
    4
    They are prone to being smack by stones so could well be a cracked lens as well.
     
    Loading...
  5. 2.4 8thGen Valued Contributor ★ ★ ★ ☆ ☆

    United Kingdom Brett Bristol
    493
    241
    1
    As speedy said you might have a small crack in the glass.
    I had this on my fog light and had to buy a new one.
    To replace I had to take half the bumper off to gain access to the fixing screws behind holding the light in.
    I would say yours will be a simula set up
     
    Loading...