Body, Paint & Styling How to Jack up and Support your 3rd Generation CR-V

Discussion in '3rd Generation (2006-2012)' started by Ichiban, Monday 30th Sep, 2013.

  1. Ichiban Founder Staff Team

    England CJ Leeds
    30,118
    6,375
    516
    How to Lift your CR-V safely?


    1. Position the lift blocks (A) under the vehicle's front support points (B) and rear support points (C).
    2. Raise the lift a few inches, and rock the vehicle gently to be sure it is firmly supported.
    3. Raise the lift to its full height, and inspect the vehicle support points for solid contact with the lift blocks.

    NOTE: If you are going to remove heavy components such as the suspension or the fuel tank from the rear of the vehicle, first support the front of the vehicle with tall safety stands. When substantial weight is removed from the rear of the vehicle, the center of gravity can change, causing the vehicle to tip forward on the lift.

    CR-V 3rd gen AOCUK Lift and Support Points.

    Safety Stands aka Axle Stands
    To support the vehicle on safety stands, use the same support points (B and C) as for a vehicle lift. Always use safety stands when working on or under any vehicle that is supported only by a jack.



    Floor Jack aka Trolley Jack
    When lifting the front of the vehicle, set the parking brake.


    1. When lifting the rear of the vehicle, put the shift lever in the P position.
    2. Block the wheels that are not being lifted.
    3. Position the floor jack under the front jacking bracket (A) or the rear jacking bracket (B). Centre the jacking bracket on the jack lift platform (C), and jack up the vehicle high enough to fit the safety stands under it.
    4. Position the safety stands under the support points, and adjust them so the vehicle is level.
    5. Lower the vehicle onto the stands


    CR-V 3rd gen AOCUK Lift and Support Points 2.
     
    Loading...
  2. Mike c Valued Contributor ★ ★ ★ ☆ ☆

    United Kingdom Mike Telford
    363
    121
    Very useful info
     
    Loading...