Electrical & Lights Instrument cluster and cruise control self-test

Discussion in '3rd Generation (2006-2012)' started by dkarolj, Sunday 12th Apr, 2015.

  1. dkarolj Junior Member ☆ ☆ ☆ ☆ ☆

    Croatia Davor Kutina
    24
    23
    Showcase of Instrument cluster and cruise control self-test using diagnostic software on Honda CR-V 2.2 I-CTDI 140HP 2007 RE6.



    There is also a manual enter mode but that doesn`t work on my car


    Entering the self-diagnostic function (manual method)
    NOTE: This procedure takes precise timing. Ill may take several tries to enter the self-diagnosis
    mode.
    Before doing the self-diagnostic function,check the No. 10 (7.5 A) fuse in the under-dash
    fuse/relay box and the No. 23 (10 A) fuse in the under-hood fuse/relay box.
    1. Push and hold the SEL/RESET switch button.
    2. Turn the headlights ON.
    3. Turn the ignition switch ON (II).
    4. Within 5 sec.,turn the headlights OFF, then ON and OFF again.
    5. Within 5 sec.,release the SEL/RESET switch button, and then push and release the button three
    times repeatedly.
    Switch Input Check
    At the initial stage of the self-diagnostic function,the beep sounds intermittently,the beeper
    sounds continuously when any of the following switch inputs are switched from OFF to ON:
    Cruise control main, SET, RESUME, CANCEL switches, SEL/RESET switch,parking brake switch,and VSA
    OFF switch.
    The illumination volume (+) and (-) switch (dash lights brightness controller) can be tested by
    turning on the headlights and verifying that the dash lights brightness changes as you turn the
    switch from full dim to full bright.
     
    Loading...
    Chunkylover53 and Nels like this.
  2. Nels Moderator Staff Team

    Thank you for posting this up Davor.
    Having a video makes it much easier to see what's going on. :Niceone:
     
    Loading...
  3. SpeedyGee Administrator Staff Team

    England Speedy Birmingham
    14,999
    5,593
    4
    Loading...