Guides Park sensors installation - Accord Tourer 7.gen

Accord Tourer 03-08

  1. Hondas Junior Member ☆ ☆ ☆ ☆ ☆

    Slovenia Miha Ljubljana
    15
    6
    1
    Hondas submitted a new guide:

    Park sensors installation - Accord Tourer 7.gen - Accord Tourer 03-08

    Check the full guide here.
     
    Loading...
  2. SpeedyGee Administrator Staff Team

    England Speedy Birmingham
    14,999
    5,595
    4
    Good work and thanks for writing the Guide.

    Just wondering, did you secure the sensor box to anything ?

    And also did you put the grommet back after running the wires to the outside ?
     
    Loading...
  3. Hondas Junior Member ☆ ☆ ☆ ☆ ☆

    Slovenia Miha Ljubljana
    15
    6
    1
    Sure, no problem.
    I did secure it with Kent, quick seal - nautical silicone.
     
    Loading...
    SpeedyGee likes this.
  4. SpeedyGee Administrator Staff Team

    England Speedy Birmingham
    14,999
    5,595
    4
    Cool :Thumbup:
    - - - Updated - - -
    So your car is LPG'd ?
     
    Loading...
  5. Hondas Junior Member ☆ ☆ ☆ ☆ ☆

    Slovenia Miha Ljubljana
    15
    6
    1
    That's right - I'm driving for about 7,5€/100km :Grin: but the transformation to LPG was pretty expensive cuz I want to have everything in top form about engine.
     
    Loading...
  6. SpeedyGee Administrator Staff Team

    England Speedy Birmingham
    14,999
    5,595
    4
    Would love to see pictures of the LPG system and the details on your Project Log for your car :Smile:
     
    Loading...
  7. Hondas Junior Member ☆ ☆ ☆ ☆ ☆

    Slovenia Miha Ljubljana
    15
    6
    1
    It's OBD Zenit PRO 4 cyl. Don't have photos of it. Will make them soon
     
    Loading...
  8. SpeedyGee Administrator Staff Team

    England Speedy Birmingham
    14,999
    5,595
    4
    I know the Zenit Pro systems well :Smile:

    Look forward to seeing the pics.
     
    Loading...
  9. Hondas Junior Member ☆ ☆ ☆ ☆ ☆

    Slovenia Miha Ljubljana
    15
    6
    1
    What do you think about it?
    I'm sorry but I don't know what means "Project Log". Even translator don't know :Smile:
     
    Loading...
  10. SpeedyGee Administrator Staff Team

    England Speedy Birmingham
    14,999
    5,595
    4
    Click on your Garage entry for your car and then click on the "Discussion" tab ... this your Project Log for your car.

    Use to detail, discuss and record stuff for your car.

    Here is direct link to it Accord/7th Generation - First Love

    Zenit Pro, is just the ECU. It has lots of features, some are really gimicky. I'd need know what injectors have been used on your car and what reducer to comment further.

    I always say that it's not about what system is used but who has installed it. A good installer can make a cheap system run really well, a bad installer can turn the most expensive system into a nightmare install.

    Post some pictures of your install when you get chance (on to your Project Log :Wink:) and I'll post my comments on it.

    In fact I might move the last few posts on this thread over to your Project Log as they are more appropriate to that rather than this reverse sensor guide.
     
    Loading...
  11. bobabobajob Junior Member ☆ ☆ ☆ ☆ ☆

    England Steve gloucester
    14
    10
    Good write-up. The only change I would suggest is to tap into the reverse wire in the wiring loom just behind the rear right hand light cluster in the boot. You can see the green wire emerging from the grey connector in the photo below. Please note that this was pre-tidying up the cabling. The other photo shows what it was like when I'd nearly finished and where I mounted the control box. Note I also fitted a switch (bizarrely a mains voltage light switch- it was all I had in the house) to disable the sensors when towing. 20150504_162928. tidy. 20150504_162928.
     
    Loading...
  12. SpeedyGee Administrator Staff Team

    England Speedy Birmingham
    14,999
    5,595
    4
    Loving the use of an electrical switch in the car @bobabobajob, never seen that before :Grin:
     
    Loading...
  13. tonygw Valued Contributor ★ ★ ★ ☆ ☆

    This is a superb guide and just at the right time for me as I am just about to replace my aftermarket faulty ones with a new set.

    Just a quick questoin, How easy is the rear bumper removal on the tourer? I see the four bolts (two on the left and two on the right) next to the rear lights, I then I guess there are the row of bolts or clips along the loading bay edge. I'm not sure whats holding the side parts of the bumper on though. Is it a quick job to remove and replace?

    Cheers
    Tony
     
    Loading...
  14. SpeedyGee Administrator Staff Team

    England Speedy Birmingham
    14,999
    5,595
    4
    It's clipped on, on the sides.

    Have a look at this guide Rear Bumper Removal & Respray
     
    Loading...
  15. Nighthawk Guest

    United Kingdom Richard Milton Keynes
    5,369
    3,146
    14
    Nice guide. I also installed a manual cut off switch to kill my parking sensors in the event that they malfunctioned etc. Got it hidden in the boot out of the way
     
    Loading...
  16. rapid1 New Member Getting Started

    Finland Jari Pirkkala
    1
    Hi Hondas,
    Could you share the pictures again of the installing parking sensor on Accord Tourer.
    I can't see them in your post, thanks!
     
  17. legend-ary Moderator Staff Team

    United Kingdom Legend The Big Smoke
    3,849
    2,281
    6
    Click the link to the guide all the photos are there
     
    Loading...