Electrical & Lights Reverse sensor positioning

Discussion in '7th Generation (2003-2008) [Acura TSX]' started by blackbeard, Sunday 7th Jun, 2015.

  1. blackbeard Club Member ★ ☆ ☆ ☆ ☆

    England England Kent
    103
    22
    Does the rear bumper on a 7th Generation tourer have any markings on it's inside face for optimum placement of reversing sensors ?
    If not , are there any examples of specific measurements or a template I can get access to , to fit some ?

    Regards

    RON.
     
    Loading...
  2. blackbeard Club Member ★ ☆ ☆ ☆ ☆

    England England Kent
    103
    22
    Just spotted the how to for this should apply equally to the aftermarket kit I intend to use................ damned senior moment again !!
     
    Loading...
  3. Nighthawk Guest

    United Kingdom Richard Milton Keynes
    5,369
    3,143
    14
    No mate, there arent any premarked holes on the inside of the bumper - when I installed mine (Cobra flush R0394 ones like the german cars use), the instructions give you minimum install height to prevent false activation of them detecting the road and each other. I used a neighbours car and measured my height off that
     
    Loading...
    blackbeard likes this.